Materials and finishes

Pick the filament that fits your part. Prices update live in the quote tool.

PLA

Everyday prototyping

Easy to print, crisp detail and a wide color range. The best default for visual prototypes, display models and low-stress parts. Softens around 55 C, so keep it out of hot cars.

Strength
Heat
Flex
Detail

Rigid, matte surface, not UV or heat resistant.

Max size 250 mm. Density 1.24 g/cm³.

Black, White, Gray, Red, Blue, Green, Orange, Yellow

PETG

Tough and chemical resistant

A durable all-rounder with good layer adhesion, slight flex and better heat and moisture resistance than PLA. Good for enclosures, brackets and functional parts.

Strength
Heat
Flex
Detail

Good impact strength. Not certified food safe.

Max size 250 mm. Density 1.27 g/cm³.

Black, White, Clear, Blue, Gray

ABS / ASA

Heat and UV capable

Engineering plastic for parts that live outdoors or near heat. We print ASA for outdoor use and ABS for general work from an enclosed chamber. Sands and smooths well.

Strength
Heat
Flex
Detail

Heat resistant to roughly 95 C. Large flat parts may show slight warping.

Max size 230 mm. Density 1.07 g/cm³.

Black, White, Gray

TPU 95A

Flexible and impact absorbing

A rubber-like elastic material for gaskets, bumpers, grips and flexible hinges. Prints slowly for reliable results.

Strength
Heat
Flex
Detail

Shore 95A. Thin walls below 1.2 mm may not hold shape.

Max size 220 mm. Density 1.21 g/cm³.

Black, White, Blue

Nylon PA12-CF

Stiff, strong carbon-fiber nylon

Carbon-fiber reinforced nylon for stiff, lightweight, high-strength functional parts, jigs and fixtures. Printed on hardened hardware with dried filament.

Strength
Heat
Flex
Detail

Matte carbon-fiber finish. Available in black only.

Max size 220 mm. Density 1.06 g/cm³.

Black

Layer height and infill

SettingBest for
0.12 mm layersFine detail and smooth curves. Slowest and highest cost.
0.20 mm layersStandard quality for most parts. Best balance of speed and finish.
0.28 mm layersFast drafts and large parts where surface finish matters less.
10 to 20% infillVisual models and light-duty parts.
30 to 50% infillFunctional parts with moderate loads.
75 to 100% infillMaximum strength and weight, for small load-bearing parts.

Finishes

As printed

Parts are removed from the build plate, supports are removed and edges are cleaned. Layer lines are visible.

Hand sanded

Surfaces are sanded to reduce layer lines and support marks. Adds $5.00 per part plus a surface-area charge and one extra day.

Get an instant quote